Home > Uncategorized > Errata - Signal Integrity for PCB Designers

Errata - Signal Integrity for PCB Designers

March 5th, 2013

The 1st ( and the only edition ) of the Signal Integrity for PCB Designers has some errors crept into it. This post enlists the errors

1. Page 101
Incorrect - T = Trace thinkness
Correct - T = Trace thickness

2. Page 106
Incorrect - These formula were designed
Correct - These formulae were designed

3. Page 110
Incorrect - t =  trac thickness
Correct - t =  trace thickness

4. Page 125
Incorrect  Figure 9-19 says it is stripline
Correct  It should be Microstrip

5. Page 131
Incorrect - ...the amount of the reflection depends upon the ration of the of the incident ...
Correct - ...the amount of the reflection depends upon the ratio of the of the incident ...

6. Page 139
Incorrect - faraad
Correct -  farad

7. Page 140
Incorrect - ., the refelection coefficient is given by
Correct - , the reflection coefficient is given by

8. Page 144
Incorrect - The source and and far end reflection functions are given by
Correct - The source and  far end reflection functions are given by

9. Page 157
Incorrect - ., The input to hspice is a simple text file with .sp extention
Correct - , The input to hspice is a simple text file with .sp extension

10. Page 181
Incorrect -  The Table below shows the measured amplitude

Correct - The figure below shows the measured amplitude

11. Page 194
Incorrect - the cross talk may be low enough with 12 mil seperation not to require guard traces
Correct - the cross talk may be low enough with 12 mil separation not to require guard traces

12. Pages 200 to 208

Incorrect - Headings say - Designing for EMI Compliance

Correct - should be Characterization of High Speed Bus

13. Page 212 - The font of following is different

l =   is the length of a segment

14. Page 233
Incorrect - Check spelling of Copper, aneealed
Correct - Should be Copper, annealed

14. Page 234
Incorrect - Check spelling of Aluminium
Correct - Should be Aluminum

Uncategorized

  1. No comments yet.
  1. No trackbacks yet.